Content | Navigation |

IE&M Program Admission Requirements

1. Overall Curriculum Requirement

A student must meet the current Industrial Engineering and Management (IE&M) curriculum or Manufacturing Engineering (MfgE) curriculum requirements in place at the time that he/she joins the program. However, for reasons including a need to observe new accreditation requirements and a credit change in a course offering, a certain program change may be applied to students accepted under a curriculum of a previous version.

2. General Education Requirements

 

A student must also meet the University General Education requirements unless he/she provides proof of having fulfilled the general education program consisting of a minimum of 36 credits from an accredited institution.

The General Education requirements are outlined in the University Registration Schedule. A student who fulfills the IE&M or MfgE curriculum requirements would automatically meet Categories 1-3 and 9-12 of the Gen. Ed. requirements. For Categories 4-8, the following check lists can be used (the term Category and CODE correspond to the Gen. Ed. requirements printed in the University Registration Schedule):

Categories 4,5,7,8

#credits*

D or G**

Course

_________ 

_______

i. One Humanity and Fine Art (CODE: A) course approved by the Gen. Ed. Committee

_________

_______

ii. ENGR 311 (CODE: A) or another Gen. Ed. course of Code A

_________

_______

iii. One Social & Behavioral Science (CODE: B) course approved by the Gen. Ed. Committee

_________

_______

iv. ENGR 312 (CODE: B, also counted as Global Perspective) or another Gen. Ed. course of Code

Note: *The total of i+ii for CODE A MUST BE AT LEAST 6 CREDITS; the total of iii+iv for CODE B MUST BE AT LEAST 6 CREDITS.
**
Among the above 4 courses, 3 credits must also be approved for Cultural Diversity (CODE: D) and 3 credits for Global Perspectives (CODE: G).

Category 6

#credits

Course

________

A Wellness course (at least 2 credits) approved by the Gen. Ed Committee (CODE: W)

3. Technical Electives (12 credits)

The following courses are approved as technical electives for the IE&M program:

IME 335

IME 380

IME 411

IME 427

IME 430

IME 431

IME 432

IME 451

IME 452

IME 453

IME 463

BUSN 310

BUSN 350

BUSN 360

BUSN 431

MIS 370

 

 

 

 

Or other engineering or business courses advised by the adviser.
* As a technical elective if this course is not counted as a required course

4. IME/UNIV 189

All freshman or transfer students with fewer than 24 transfer credits are required to take IME/UNIV 189.

5. IME 111

All freshmen are required to take IME 111. For transfer students IME 111 requirement may be waived depending on the student's previous coursework.

6. Co-op Education

All students are encouraged to have a cooperative education. A co-op education significantly enhances the IME educational experience and career preparation.


Student Focused. Land Grant. Research University.

Follow NDSU
  • Facebook
  • Twitter
  • RSS
  • Google Maps

North Dakota State University
Phone: +1 (701) 231-7287 / Fax: (701) 231-7195
Campus address: Civil and Industrial Engineering 202
Physical/delivery address: 1410 14th Avenue North, Fargo, ND 58102
Mailing address: NDSU Dept. 2485 / PO Box 6050 / Fargo, ND 58108-6050
Page manager: Industrial and Manufacturing Engineering
Facebook page: Visit NDSU IME on Facebook

Last Updated: Friday, December 05, 2014 2:47:46 PM