1. Overall Curriculum Requirement

A student must meet the current Industrial Engineering and Management (IE&M) curriculum or Manufacturing Engineering (MfgE) curriculum requirements in place at the time that he/she joins the program. However, for reasons including a need to observe new accreditation requirements and a credit change in a course offering, a certain program change may be applied to students accepted under a curriculum of a previous version.

2. General Education Requirements

A student must also meet the University General Education requirements unless he/she provides proof of having fulfilled the general education program consisting of a minimum of 36 credits from an accredited institution.

The General Education requirements are outlined in the University Registration Schedule. A student who fulfills the IE&M or MfgE curriculum requirements would automatically meet Categories 1-3 and 9-12 of the Gen. Ed. requirements. For Categories 4-8, the following check lists can be used (the term Category and CODE correspond to the Gen. Ed. requirements printed in the University Registration Schedule):

Categories 4,5,7,8

#credits*	D or G**	Course
_________	_______	i. One Humanity and Fine Art (CODE: A) course approved by the Gen. Ed. Committee
_________	_______	ii. ENGR 311 (CODE: A) or another Gen. Ed. course of Code A
_________	_______	iii. One Social & Behavioral Science (CODE: B) course approved by the Gen. Ed. Committee
_________	_______	iv. ENGR 312 (CODE: B, also counted as Global Perspective) or another Gen. Ed. course of Code

Note: *The total of i+ii for CODE A MUST BE AT LEAST 6 CREDITS; the total of iii+iv for CODE B MUST BE AT LEAST 6 CREDITS.
** Among the above 4 courses, 3 credits must also be approved for Cultural Diversity (CODE: D) and 3 credits for Global Perspectives (CODE: G).

Category 6

#credits	Course
________	A Wellness course (at least 2 credits) approved by the Gen. Ed Committee (CODE: W)

3. Technical Electives (12 credits)

The following courses are approved as technical electives for the IE&M program:

IME 335	IME 411	IME 427	IME 435	IME 450
IME 451	IME 462	IME 463	IME 470	IME 472
IME 485	IME 494	IME 496	BUSN 310	BUSN 350
BUSN 360	BUSN 431

Or other engineering or business courses advised by the adviser.
* As a technical elective if this course is not counted as a required course

4. IME/UNIV 189

All freshman or transfer students with fewer than 24 transfer credits are required to take IME/UNIV 189.

5. IME 111

All freshmen are required to take IME 111. For transfer students IME 111 requirement may be waived depending on the student's previous coursework.

6. Co-op Education

All students are encouraged to have a cooperative education. A co-op education significantly enhances the IME educational experience and career preparation.